Why are people still using ND dies even at the double cost?

Wire drawing is a metalworking process used to reduce the cross-section of a wire by pulling the wire through a single, or series of, drawing dies. There are many applications…

Read more »
router-bits

Are you still using CMT woodworking router bits in 2022?

The compound spiral knife is a combination of the upper rotary blade and the lower rotary blade on the same tool. The upper and lower blades cut the compressible workpiece at the same time to avoid the generation of chips or burrs on the top or bottom of the workpiece.

Read more »

How to replace the old flat type with a new spiral cutter shaft?

Spiral cutter shaft installation steps When the spiral cutter shaft has been installed on the machine and the blade is replaced, the power supply of the equipment must be turned…

Read more »

How can the heavy-duty spiral cutter adapt to all kinds of wood?

First, we would like to introduce the Structural composition of heavy-duty spiral cutter shaft The figure shows the finished picture of the heavy-duty spiral cutter shaft, which includes 9 parts:…

Read more »

Do you know how to adjust a set of edge banding machine knives?

A set of edge banding machine knives include a lot, like Diamond pre-milling cutter, flush saw blade, fine trimming knife, roughing milling cutter, edge cutter etc. How to adjust the…

Read more »